Table of Contents
Advertisement
7
8
42
1
2
3
4
5
6
Cross clamp cylinder
Just before the folding device reaches the sewing position the cross
clamp cylinder 1 turns the swing clamp against the fixed clamp at full
pressure. This sufficiently clamps the cloth in the area of the
lengthwise seam.
–
Loosen lock nut 2.
–
Turn the extension 3.
The pressure against the fixed clamp must be sufficiently strong in
the area of the lengthwise seam.
–
Tighten lock nut 2.
Trim clamp cylinder
When the folding device has reached the sewing position the trim
clamp cylinder 4 presses the swing clamp in the rear area downward
against the fixed clamp.
–
Loosen screws 6
–
Alter the position of the cylinder holder 5 appropriately.
–
Tighten screws 6 again.
Speed when opening and closing
–
Set the program switch to 41 and press the " STOP " key.
With the " REPEAT " key run through the function sequence in
interval operation.
–
Observe the movement of the swing clamp when opening and
closing.
The swing clamp should move quickly and uniformly. If not, set the
throttles 7 and 8 accordingly.
Advertisement
Table of Contents
