Position Of The Switching Disks On The Shaft - Duerkopp Adler 975-1-5 Service Instructions Manual

4.4.2 Position of the Switching Disks on the Shaft

The switching disks no.s 1 to 10 are arranged as per the setting disk.
The switching disks no.s 3 to 10 are deployed as pairs ( 3 + 4,
5 + 6, 7 + 8, 9 +10 ).
Caution Risk of Injury !
Turn the main switch off.
Set the switching disks only with the sewing unit turned off.
Switching Disk
No. 1 165°
No. 2 245°
No. 4 245°
No. 6 30°
No. 8 163°
No. 10 232°
3
–
Bring the folding device of the clamping table into the base position.
–
Screw setting disk 3 onto the shaft 2.
Align the setting disk so that the 0° position agrees with the edge 1
of the mounting plate for the valves.
–
Set the program switch to 40 and press the " STOP " key.
With the " REPEAT " key turn the shaft with the switching disks to
the various positions and align.
–
Check the switching points in automatic operation.
Caution Risk of Injury !
Conduct a function test with the greatest possible caution.
If necessary correct the position of the switching disks.
1
2
Function
Valve released
Valve released
Valve operated
Valve operated
Valve operated
Valve released
- Inner forward slide forward
- Fixed clamp pressure-free
- Swing clamp opens
- Hold-down back
- Interior slides operated
- Cross clamp cylinder
has full pressure
37