Position Of The Clamping Tablees - Duerkopp Adler 975-1-5 Service Instructions Manual

4.5 Position of the Clamping Tables
38
1
2
3
4
5
The position of the clamping table determines the position of the seam
formation on the trim.
Before the contour determining elements are set, the position of the
clamping table must first be set.
Caution Risk of Injury !
Turn the main switch off.
Set the position of the clamping table only with the sewing unit turned
off.
–
Loosen screws 2, 3 and 5.
–
Loosen the lock nuts.
–
Set the adjustment screws 1 and 4.
Set the position of the clamping table so that the clearance of the
short side seam is 1 mm.
The smaller the edge interval is to be, the farther the clamping
table must be distanced from the machine head.
–
Tighten the lock nuts.
–
Tighten screws 2, 3 and 5.
The two clamping plates are present at each clamping table !
The setting is to be made with both clamping plates !
–
Conduct a function test with low cutting rpm.
Set the program switch to 41 and press the " STOP " key.
Caution Risk of Injury !
Conduct a function test with the greatest possible caution.
The needle hole mushroom should not touch the fixed clamp !
The needle should not touch the fixed clamp !
If necessary correct the position of the clamping table.