Clearance Between The Thread Puller And The Burner; Position Of The Swung-Forward Burner - Duerkopp Adler 506 Service Instructions Manual

11.3.3 Clearance between the Thread Puller and Burner
4

11.3.4 Position of the Swung-forward Burner

40
The clearance between the thread puller 2 and the burner 1 must
be approx. 6 mm in the forward area.
5
Caution Risk of Injury !
Turn the main switch off.
Set the clearance between the thread puller 2 and burner 1 only with
the main switch turned off.
–
Tilt the machine head to the side.
–
Loosen screws 3 slightly.
–
Set the correct clearance by relocating the thread puller 2.
–
Tighten screws 3.
The left side of the burner 1 must end in line with the outer edge
of the needle hole bushing 6.
Caution Risk of Injury !
Turn the main switch off.
Set the position of the burner 1 only with the main switch turned off.
–
Loosen the lock nut 5.
–
Set the position of the burner by turning the stopper screw 4.
–
Tighten the lock nut 5.
3
1
2