Setting The Interior Slides - Duerkopp Adler 975-1-5 Service Instructions Manual

4.8.1 Setting the Interior Slides

1
2
3
Prerequisite for the setting of the interior slides is the correct
positioning of the clamping table (short side seam d see Page 44).
Caution Risk of Injury !
Turn the main switch off.
Set the interior slides only with the sewing unit turned off.
Position of the interior slide-Swing table
The clearance of the trim edge a to the long side seam is 1mm.
The clearance of the trim edge b to the pointed seam is 1mm.
–
Loosen nut 2.
Align the interior slide parallel to the swing clamp.
Tighten nut 2 again.
–
Loosen screws 3.
Set the interior slide so that this extends sideways 1.5 mm relative
to the swing clamp.
Tighten screws 3 again.
–
Loosen screws 1.
Set the interior slide so that this extends forward 1.5 mm relative to
the swing clamp.
Tighten screws 1 again.
ATTENTION !
If the interior slide was changed in the sideways direction,
then the position of the side slide of the swing table is to be checked
and possibly to be corrected.
a b
45