Table of Contents
Advertisement
4.9 Side Slides
1
3
2
2
The side slides fold the trim around the interior slides.
1 = Side slide-Swing table
2 = Side slide-Fixed table
In the sleeve feed position of the folding device the interior slide
should hang down. It is therefore held by 2 pins of the swung-forward
side slide.
The hold-down is only then swung back when the side slide is
somewhat above the interior slides.
During of the folding sequence the outer forward slide is swung under
the side slide. The strip below the side slide may not extend into the
slewing area of the outer forward slide. This leads to the trim at this
position not being folded around the side slides with sharp edges.
Slightly variing edge intervals on the side seam cannot be avoided.
Caution Risk of Injury !
Turn the main switch off.
Set the side slides only with the sewing unit turned off.
Conduct a function test with the greatest possible caution.
–
Loosen screws 3.
–
Align the side slides 2.
The swung-completely-forward side slides should have a
clearance in agreement with the median material thickness.
The smaller the gap to the side slides the sharper is the folding.
The side slide should not collide with the retracted inner forward
slide during its forward movement.
–
Tighten screws 3.
–
Set the program switch to 41 and press the " STOP " key.
With the " REPEAT " key run through the function sequence in
interval operation.
47
Advertisement
Table of Contents
