Table of Contents
Advertisement
4.1.1 Attaching the Aluminium Strips
1
The aluminium strips are attached to the side surfaces of the large
guide curve 1.
The position of the aluminium strips is shown for the right clamping
table. For the left clamping table it is a mirror image.
Caution Risk of Injury !
Turn the main switch off.
Attach the strips only with the sewing unit turned off.
–
With the hand crank run the clamping table to the switching points
1, 2, 3, 4 and 6. Mark each of the switching points on the side
surface of the guide curve.
Switching point 1 is reached when the direction of movement of the
clamping table no longer changes.
Switching point 5 results from the length of the strip.
–
Mark the delay distances on the guide curve.
Because of the reaction times the signals must be triggered earlier
accordingly.
Points: 1, 2 ,6
Points: 3, 4
Delay distance approx. 10 mm
–
Cut the strip to size.
1 to 2: appropriate to the marking (taking delay distances into account)
3 to 5: 400 mm
4:
70 mm
6:
80 mm
–
Attach the strips.
4 and 6:
Top
1 until 2:
Center
3 until 5:
Bottom
–
Check the switching points in automatic operation.
Caution Risk of Injury !
Conduct a function test with the greatest possible caution.
If necessary correct the position and length of the aluminium strips.
Delay distance approx. 20 mm
31
Advertisement
Table of Contents
