Position Of The Aluminium Strips On The Guide Curve - Duerkopp Adler 975-1-5 Service Instructions Manual

4.3.3 Position of the Aluminium Strips on the Guide Curves
The aluminium strips 1 on the faces of the 3 guide curves stop their
turning movement according to the function sequence.
Caution Risk of Injury !
Turn the main switch off.
Attach the aluminium strips to the guide curves only with the sewing
unit turned off.
Guide Curve
No. 1 A =
No. 2 B = 235°
No. 3 C = 116°
D = 177°
E = 261°
4
–
Bring the folding device of the clamping table into the base position.
–
Cut the aluminium strips to size.
A = 80 mm.
–
Screw the setting disk 4 onto the shaft 3.
Align the setting disk so that the 0° position agrees with the edge 2
of the mounting plate for the valves.
–
Set the program switch to 40 and press the " STOP " key.
Turn the shaft with the guide curves into the individual positions
using the " REPEAT " key.
–
Attach the aluminium strips.
–
Check the switching points in automatic operation.
Caution Risk of Injury !
Conduct a function test with the greatest possible caution.
If necessary correct the position and length of the aluminium strips.
1
2
3
Function
0° Initial position of the folding device
Sewing position of the folding device
Insert the sleeve
Short intermediate stop
Remove the cloth
B, C, D, E = 15 mm.
35