Mount The Oil Lines; Mount The Control Panel - Duerkopp Adler 510 Operating Instructions Manual
Cnc automat for bartacking seams and short seams
Hide thumbs
Also See for 510:
- Operating instructions manual (103 pages) ,
- Parts list (58 pages) ,
- Operating/service instructions manual (46 pages)
Table of Contents
Advertisement
4.3 Mount the oil lines
4.4 Mount the control panel
12
10
–
Fasten the oil lines 8 and 9 in the oil pan by means of fitting 10.
The oil filter must be completely surrounded by the felt.
4
–
Screw the control panel 4 on the automatic bartacker with angle 3.
Lay rubber washers between the mounting angle of the control
panel and the cast housing.
–
Run the connecting cable 2 under the table top through oil pan 1.
9
8
3
2
1
Advertisement
Table of Contents
