Canopy Installation; Hanging The Fan; Canopy Electrical Connections - Casablanca UTOPIAN Instructions Manual

Hide thumbs Also See for UTOPIAN:

Owner's manual (10 pages)

Installation manual (23 pages)

Service manual (15 pages)

Table of Contents

Step 2. Thread the wires from the ceiling through

the opening in the canopy. Attach the canopy to

the crossbar mounting bracket with three of the

8-32 x 2

long canopy screws and canopy lock

washers.

Using the screwdriver, tighten the screw firmly by

hand only.

Note: On sloped ceilings, align the

canopy opening toward the top or

room peak.

Step 3. To hang the fan body in the

canopy, hold the fan body firmly and in-

sert the ball into the canopy opening.

Check that no wires were pinched. Ro-

tate the fan body until the slot in the

ball fits into the pin opposite the canopy

opening.

Step 4a. Attach the fan wires to the ceiling fixture outlet

box wiring by placing the bare ends of the wires side by side

and then securing with a wire nut. Test that the connection

is secure by pulling on the wire nut. Connect in this order:

Step 4b. Pull Chain Connections

• GREEN leads from mounting plate and fan to GROUND con-

ductor of power source. Secure with wire nut.

• WHITE wire from fan to white NEUTRAL wire in ceiling

fixture outlet box. Secure with wire nut.

• BLUE wire and BLACK power wire from fan to BLACK power

wire in ceiling outlet box. Secure with wire nut.