Adjust Main Clamp Height; Adjust Main Clamp Pressure; Main Clamp Pressure Distribution - Beisler 100 Operating Instructions Manual

1.6 Adjust main clamp height

The main clamp height in insertion position must be 30
mm.
To adjust this, loosen the nuts (1) at both clamp pressu-
re cylinders and turn the piston pole (2) until the must
height is present.

1.7 Adjust main clamp pressure

The clamp pressure must be 3.5 bar. You can read it at
the pressure gauge (1) on the clamp carriage.
To adjust the pressure, pull out the black knob and turn
it into the required direction. Press the knob down again.

1.8 Main clamp pressure distribution

An even pressure must be over the whole main clamp
area.
Drive the main clamp into insertion position and lay thin
sewing material under the clamp arms. Close the main
clamp (control: check outputs). Pull the sewing material
laterally and check the even clamp pressure.
If required, you can adjust the pressure distribution. Loo-
sen the fixing screws (1) of the two allen screws (2).
Turn the two allen screws (2) until the correct pressure
distribution is present. Tighten both fixing screws (1)
again.
3-7