Demount Vylene Plate; Change Cutting Pressure; Adjust Vylene Supply; Easy-Running Of The Vylene Roll - Beisler 100 Operating Instructions Manual

5.5.2 Demount vylene plate

<power off> <release pressure>
Pull out the vylene strip (3) from the supply slot.
Loosen the fixing screw (2) of the roll (3) and take this
out by pulling to the left.
Loosen the three fixing screws (4) of the vylene plate.
Assure that the vylene plate cannot tilt away.
Loosen the fixing screw of the table support (5) and swing
it to the front or back.
Now you can take out the vylene plate.
ATTENTION
Assure that the hoses at the vylene won't be dama-
ged. We recommend to leave the hoses at their
positions.

5.5.3 Change cutting pressure

Loosen both allen keys (1) and move the counter knife
(No. 2 in picture at section 5.5.1) until an adequate cut-
ting pressure is present.
Tighten both allen screws.

5.5.4 Adjust vylene supply

The vylene must to be seen when the sliding plate is
inserted. To adjust the supply, loosen the fixing screw
(2) at the cylinder (4) and move this correspondingly.
Tighten the fixing screw again.

5.5.5 Easy-running of the vylene roll

The vylene roll must run easily.
Loosen one of the allen screws (3) and push the roll,
until it runs easily. Tighten the loosened allen screw.

5.5.6 Vylene supply speed

The vylene supply must be adapted and synchronized
to the clamp speed.
Adjust the throttle (1) to change the vylene supply speed:
turn right: slower
turn left: faster
3-28
Hint
By adjusting the fixing screws (4) it is possible to adapt
the height of the vylene plate to the table height.