Beisler 100 Operating Instructions Manual page 13

All information required for the operation of the machine will be imaged in the
display. During normal production the display shows the following (see Pict.
6):
• the graphic on the left side images the mitre cut of the pocket; in the
shown example, the mitre cutter cuts the basic value 50 at the seam start
and 0.5 mm less at the end, that is the value 45
• the graphic to the right shows the seam or flap lenght of the pocket; the
value displayed above the flap (33.0) defines, how far the flap will be
pushed behind the needle, after the photocell has recognized the flap
(value for the seam start); the value displayed below the flap (40.0)
defines, how long the machine continues sewing, after the photocell has
recognized the end of the flap
• the most upper line shows the number of the selected program (M01) and
the seams assigned to this program (30, 31, 32 and 33); seams 30 and
32 are enabled (32 will be the next seam to be sewed), 31 and 33 are
disabled
• the name of the current seam is displayed to the right
• the square below contains the icons of the machine functions assigned to
the current seam
• below the square, the stock of bobbin thread (45 m) and the number of
produced parts (149) are displayed
4.1.1.4 Ten key pad with P- and M-key
Numerical inputs can be done using the ten key pad.
The letters displayed below the digits can be entered, after the function key
with the corresponding color indication has been pressed before.
The P-key is used in several steps of the machine programming.
Sewing programs can be selected after pressing the M-key.
4.1.1.5 Function keys – lower occupation
The function keys are occupied as follows
switches to the upper occupation of the function keys
Mitre knife correction; press this key once to change the mitre
knife position at the seam start; press F1 and the cursor stands
on the seam start; press twice to change the position at the
seam end; after pressing F1, enter the new value using the ten
key pad, which will be displayed in the left-handed graphic; 50 =
middle value; the higher the value, the more far the mitre knife
cuts to the outside
e.g. old value 50, new value 56 and the mitre knife cuts 0.6 mm
more to the outside
e.g. old value 50, new value 22, the mitre knife cuts 2.8 mm
more to the inside
1-11