Beisler 100 Operating Instructions Manual page 40

Error 28: No impulses
from sewing engine
Error 29: Sewing engine
too fast
Error 30: Thread cutter
position doesn't come
Error 33: Sewing engine
doesn't stop
Error 34: Needle not up
Error 35: Thread broken
Error 36: Spool empty
Error 37: Spool only
residual
Error 41: No flap
Error 42: Photo cell not
lighted
Error 43: Photo cell
lighted too early
Error 45 ... 48: I/O
DACI/O ULNI/O 485I/O
RES
Error 51: Flap station
doesn't swing
Continuation: see bottom of left-handed side
2-20
no impulses from sewing engine
after sewing start (engine doesn't
work)
during thread cutting the sewing
enginge couldn't reach cutting
speed within error time
the sewing engine hasn't reached
the position for thread cutting
engine doesn't stop within error
time after thread cutting
needle couldn't reach the top
position; with the error message the
control tries to put the needle into
the top position again
threat monitor detects breakage
mode 'Bottom thread counter'
enabled; remaining length is zero
one of the photo cells at the spool
capsule is lighted, the spool is
empty
automatic flap legth detection with
phot cell is enabled but no flap is
detected
automatic flap length detection with
photo cell enabled; no flap within
the security length detected
automatic flap length detection with
photo cell enabled; photo cell
detected flap end too early
internal hardware errors during data
transfer to adaption board 9020020
flap station couldn't reach the active
position within error time
check sewing engine and synchronizationcheck
connection 9020013 > sewing engineread two
upper diodes at 9020013: left lights shortly if
needle in top position; right shows synchronizator
impulses (512 impulses per turn); if none lights
while turning the hand wheel, check power
supply; possibly change sewing engine
if diodes are working and engine doesn't move
before error message, check connection 9020020
> sewing engine; possibly change 9020020 or
engineif engine works shortly before error messa-
ge, check connection controls > I/O module;
possibly change components
change sewing engine or synchronizator
set a slower cutting speedset an earlier cutting
positionchange sewing engine or synchronizator
set a slower cutting speed; set an earlier cutting
position; change sewing engine or synchronizator
check sewing engine and synchronizator; check
connection 9020013 > sewing engine; read two
upper diodes at 9020013: left lights shortly if
needle in top position; right shows synchronizator
impulses (512 impulses per turn); if none lights
while turning the hand wheel, check power supply;
possibly change sewing engine
if diodes are working and engine doesn't move
before error message, check connection 9020020
> sewing engine; possibly change 9020020 or
engine
if both spools are not empty, one photo cell
reflects the thread and must be set smaller
insert flapcheck photo cell ES31 and film
program a longer security lengthswitch off super-
vision (enter 250 mm as seam length)check photo
cell ES31 and film
program a shorter security lengthswitch off
supervision (enter 250 mm as seam length);
check photo cell ES31 and filmset photo cell
sensitivity smaller (reflections?)
change 9020020
check cylinder, gauge Y17, termination switch
ES08