Mitre Knife Slant Position; Distance Between Basic Bodies; Height Adjustment; Center Adjustment - Beisler 100 Operating Instructions Manual

5.3 Mitre knife slant position

5.3.1 Distance between basic bodies

<power off> <release pressure>
The distance (A) between the basic bodies of the mitre
knifes must be 3 mm in home position (both knifes com-
pletely right).
To set the distance you will have to move the initiator
and adjust the mechanical stop.
Loosen the fixing screws (2) of the initiator (1) and move
it until the required distance is present in the home posi-
tion.
Push aside the movable mitre knife, loosen the counter
nut of the mechanical stop (3) and turn this in or out.
Tighten the counter nut.

5.3.2 Height adjustment

This is done similar to the height adjustment of the stan-
dard mitre knifes (see section 4.3).

5.3.3 Center adjustment

For the center mitre knife a lateral adjustment must be
executed. This is done similar to the adjustment of the
standard mitre knifes (see section 4.6).

5.3.4 Adjust mitre knife stops

The mitre knife stops must be adjusted at both mitre
knifes. The adjustment procedure is similar and is shown
here for the example of the movable mitre knife:
The right stops (1) are adjusted by loosening the coun-
ter nuts (2) und turning the screws (1) in or out. Tighten
the counter nuts again.
The left stops (4) are adjusted by loosening the counter
nuts (3) and turning the allen screws (4) in or out. Tigh-
ten the counter nuts again.
ATTENTION
Adjust the stops equally. The basic body of the mitre
knifes must have an equal contact to the upper and
lower stop.

5.3.5 Knife arrangement

Assure to insert the knifes in the correct order when chan-
ging the knifes.
At the locked knife for the seam end, the cutting blades
must show an concave bow (left side in the drawing).
At the movable knife for the seam start, the cutting bla-
des must show an convex bow (right side in the dra-
wing).
3-26