Adjust Clamp Path; Adjust Front Stop; Measure Clamp Path; Adjust Back Stop Rubber - Beisler 100 Operating Instructions Manual

1.20 Adjust clamp path

1.20.1Adjust front stop

<release pressure>
Drive the clamp carriage (1) into insertion position intil
initiator 1 (2) switched dark. The distance (A) between
the beam and the clamp carriage must be 19 mm.
To adjust the distance, loosen the fixing screws of the
initiator 1 (2) and move him in the desired direction. Tigh-
ten the fixing screws again.
Loosen the fixing screw of the stopping rubber (3) and
turn this in or out, until there is a distance (B) of 3 mm to
the clamp carriage. Tighten the fixing screw again.

1.20.2Measure clamp path

Switch on the machine with the mains/emergency stop
switch. Wait until the clamp has been initialized.
The machine must be in home position (clamp carriage
in the back position).
Press sequently the keys [P] – [F6] – [F3] – [F3] – [F1] at
the operation device.
Push the clamp forward into insertion position until in-
itiator 1 switches dark. Check the value which is display-
ed in the lower right corner of the display (in mm):
< 000 mm initiator 17 (see picture in section 1.20.3) is
too far in the back and must be adjusted
towards the sewing head.
= 000 mm initiator 17 is adjusted correctly.
> 000 mm initiator 17 is too far in the front and must
be adjusted away from the sewing head.

1.20.3Adjust back stop rubber

The stop rubber (1) beside initiator 17 (I 17) must show
a gap of 3 mm to the clamp carriage.
Drive the clamp carriage into home position. Loosen the
nut (2) and turn the stop rubber, until there is a distance
of 3 mm to the clamp carriage. Tighten the nut (2) again.
3-12