HP BL260c - ProLiant - G5 Troubleshooting Manual page 70

Step Midplane assembly replacement action and verification
Step 1 Action
Contact an authorized service provider to perform the following steps:
1 Power down all server blades.
2 Disconnect power from the enclosure.
3 Remove all devices from all device bays. Be sure to note the location for each
device.
4 Remove all interconnect modules.
5 Remove all fans.
6 Remove all Onboard Administrators from the enclosure.
7 Remove the OA tray.
8 Remove the rear cage.
9 Remove the midplane assembly.
10 Install a service spare midplane assembly.
11 Install the rear cage.
Step 2 Action
1 Install following components in their original locations in the enclosure:
•
Power supplies
•
Fans
•
Onboard Administrator
•
OA tray
2 Power up the enclosure.
Verification
When the Insight Display indicates that the Onboard Administrator has completed all
power-on tests, continue to the next step.
Step 3 Action
Update the PID and serial numbers:
1 Locate the enclosure label on the front left mounting tab.
2 Record the enclosure PID and serial number.
3 Log in to OA CLI using the Administrator account.
4 Update the enclosure part number using the following OA CLI command. In place of
X, enter the PID number.
5 Update the enclosure serial number using the following OA CLI command. In place
of X, enter the serial number.
Verification
If troubleshooting the HP BladeSystem c3000 Enclosure, then continue to step 5.
If troubleshooting the HP BladeSystem c7000 Enclosure, then continue to the next step.
set enclosure part_number X
set enclosure serial_number X
Midplane assembly replacement 70