HP BL260c - ProLiant - G5 Troubleshooting Manual page 23

Step HP BladeSystem c7000 Enclosure Insight Display action and verification
Verification
1 Wait for up to 2 minutes, and then check the Insight Display.
2 Do one of the following:
•
If the Insight Display illuminates and the Insight Display buttons operate, then install
the standby Onboard Administrator (OA #Y), if present, in OA bay Y. The repair is
complete.
•
If the issue still exists, then continue to the next step.
Step 10 Action
Test the OA tray:
1 Remove the active Onboard Administrator (OA #X).
2 Remove the OA tray and install a service spare or known-working OA tray.
3 Install the active Onboard Administrator (OA #X) in OA bay X.
Verification
1 Wait for up to 2 minutes, and then check the Insight Display.
2 Do one of the following:
•
If the Insight Display illuminates and the Insight Display buttons operate, then install
the standby Onboard Administrator (OA #Y), if present, in OA bay Y. The repair is
complete.
•
If the issue still exists, then continue to the next step.
Step 11 Action
Request authorization to remove all devices from device bays 9 and 10.
Step 12 Action
Test the Insight Display cable connection:
1 Power down the devices installed in device bays 9 and 10.
2 Remove the devices from device bays 9 and 10.
3 Remove the two screws from the metal plate covering the Insight Display cable
connector on the left inside wall of the enclosure.
4 Carefully reseat the Insight Display cable.
HP BladeSystem Insight Display troubleshooting 23