HP BL260c - ProLiant - G5 Troubleshooting Manual page 21

Step HP BladeSystem c7000 Enclosure Insight Display action and verification
Verification
1 Wait for up to 2 minutes, and then check the Insight Display.
2 Do one of the following:
•
If the issue still exists, continue to the next step.
•
If the Insight Display illuminates and the Insight Display buttons operate properly,
then test the OA tray connection. Continue to step 9.
Step 6 Action
Test the Onboard Administrator:
1 Remove OA #X.
2 Install the OA #Y, if present, or a known-working Onboard Administrator into OA
bay 1.
Verification
1 Wait for up to 2 minutes, and then check the Insight Display.
2 Do one of the following:
•
If the issue still exists, then test the OA tray connection. Continue to step 9.
•
If the Insight Display illuminates and the Insight Display buttons operate properly,
then OA #X failed.
If OA #X has failed, do one of the following:
•
If replacing OA #X with a service spare part, then continue to the next step.
•
If replacing OA #X with OA #Y, then continue to step 8.
Step 7 Action
Obtain the OA1 IP settings from the enclosure administrator.
Static OA1 IP settings:
1 Use the Insight Display Enclosure Settings information to change the OA1 IP address
to static.
2 Enter the following information recorded in the previous step:
•
IP address
•
Netmask
•
Gateway
3 Record or tear off the replaced Onboard Administrator password from the label on
the OA tray.
DHCP OA IP settings:
1 Use the Insight Display Enclosure Settings information to change the OA1 IP address
to DHCP.
2 Record the following information:
•
New OA IP address
•
DNS name of the old Onboard Administrator from the label
•
DNS name of the new Onboard Administrator from the label
3 Record or tear off the replaced Onboard Administrator password from the label on
the OA tray.
HP BladeSystem Insight Display troubleshooting 21