HP BL260c - ProLiant - G5 Troubleshooting Manual page 22

Step HP BladeSystem c7000 Enclosure Insight Display action and verification
Verification
When the IP address is updated for the new Onboard Administrator, then the hardware
repair is complete. Continue with the configuration.
Configuration
Complete the configuration:
1 If the OA1 IP address is 0.0.0.0 and is set for DHCP, then the network administrator
modifies the DHCP server configuration to add the new OA MAC address. The OA
MAC address is found in the new OA default DNS name.
2 Log in to the new Onboard Administrator using the Administrator account and the
new password.
3 Verify that the Onboard Administrator firmware is the correct version. Update the
Onboard Administrator firmware, if necessary.
4 Complete the Onboard Administrator setup wizard or restore a previously saved
enclosure configuration file.
5 If not using LDAP for authentication, then manually update the passwords.
Step 8 Action
Replace the failed Onboard Administrator:
1 Install OA #Y in OA bay Y.
2 Install a service spare Onboard Administrator in OA bay X.
3 Obtain the original OA #X (original standby OA) IP address settings from the
enclosure administrator.
4 Use the Insight Display to update the new OA #X IP address settings to match the
settings from the original OA #X.
Verification
After replacing the Onboard Administrator, the hardware repair is complete. Continue
with the configuration.
Configuration
Complete the configuration:
1 Log in to OA #Y using the Administrator account and the new password.
2 Verify that the standby Onboard Administrator (OA #X) firmware is the correct
version.
3 Update the active Onboard Administrator firmware, if necessary, to synchronize the
firmware on both Onboard Administrators. This update also synchronizes the
enclosure settings on the standby Onboard Administrator.
4 Verify the original IP address settings for the standby Onboard Administrator (OA
#X).
Step 9 Action
Test the OA tray connection:
1 Remove the active Onboard Administrator (OA #X).
2 Reseat the OA tray.
3 Install the active Onboard Administrator (OA #X) in OA bay X.
HP BladeSystem Insight Display troubleshooting 22