HP BL260c - ProLiant - G5 Troubleshooting Manual page 49

Step Onboard Administrator errors action and verification
Verification
Wait until the the Insight Display indicates that the Onboard Administrators have
completed power-on tests.
If the active Onboard Administrator operates properly, then the repair is complete.
If the active Onboard Administrator symptoms still exist, then replace the OA tray and
continue to step 9.
Step 8 Action
Contact an authorized service provider to complete the midplane assembly replacement
(on page 69).
Step 9 Action
Obtain the OA1 IP settings from the enclosure administrator.
Static OA1 IP settings:
1 Use the Insight Display Enclosure Settings information to change the OA1 IP address
to static.
2 Enter the following information recorded in the previous step:
•
IP address
•
Netmask
•
Gateway
3 Record or tear off the replaced Onboard Administrator password from the label on
the OA tray.
DHCP OA IP settings:
1 Use the Insight Display Enclosure Settings information to change the OA1 IP address
to DHCP.
2 Record the following information:
•
New OA1 IP address
•
DNS name of the old Onboard Administrator from the label
•
DNS name of the new Onboard Administrator from the label
3 Record or tear off the replaced Onboard Administrator password from the label on
the OA tray.
Configuration
When the IP address is updated for the new Onboard Administrator, then the hardware
repair is complete.
To complete the configuration, perform the following steps:
1 If the OA1 IP address is 0.0.0.0 and is set for DHCP, then have the network
administrator modify the DHCP server configuration to add the new OA MAC
address. The OA MAC address is found in the new OA default DNS name.
2 Log in to the new Onboard Administrator using the Administrator account and the
new password.
3 Verify that the Onboard Administrator firmware is the correct version. Update the
Onboard Administrator firmware, if necessary.
4 Complete the Onboard Administrator setup wizard or restore a previously saved
enclosure configuration file.
5 If not using LDAP for authentication, then manually update the passwords.
Enclosure troubleshooting 49