Transmission - Olivetti Fax_Lab 710 Instructions Manual

T
RANSMISSION
If you follow the procedures described below, you can imme-
diately use the fax machine to carry out simple trans-
mission operations. In any case, if these procedures are
not enough for you, see the "Transmission and reception
operations" chapter, which provides a detailed description
of all the transmission modes and how to program the phone
book.
W
HAT DOCUMENTS MAY BE USED
For any type of tansmission, the document has to be
placed in the ADF.
CHARACTERISTICS OF THE ORIGINAL
Sizes:
• Breadth min. 148 mm - max. 216 mm
• Length min. 216 mm - max. 600 mm
Unit weight of sheet:
2
• 80 g/m (max. 20 sheets)
2
• 60 - 90 g/m (max. 10 sheets)
2
• 50 - 140 g/m (1 sheet at a time)
For documents of different sizes from those specified above,
photocopy the original onto A4 sheets or another supported
format and send the copy.
1
2. Place the document with the side to be sent face up (automatic
document feed).
Once the document has been inserted in the automatic docu-
ment feeder (ADF), the display shows on the top line:
and on the bottom line, the default contrast value: "NORMAL".
T
O SEND A DOCUMENT
1. Push the document support into
the slot until it clicks into position.
1. If these diagrams are not enough,
see "To send a document",
section "Transmission and re-
ception operations".
T
O HEAR THE DIALLING TONE WHEN SENDING A DOCUMENT
1. If these diagrams are not enough,
T
O SEND A DOCUMENT WITH THE RECEIVER RAISED
1. If these diagrams are not enough,
see "To send a document",
section "Transmission and re-
ception operations".
see "To send a document",
section "Transmission and re-
ception operations".
17