Configuring Vtp Client Mode - Cisco WS-C2950-24 Configuration Manual

Using VTP

Configuring VTP Client Mode

Caution
Command
Step 1
vlan database
Step 2
vtp client
Step 3
vtp domain domain-name
Step 4
vtp password password-value
Step 5 exit
Step 6
show vtp status
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
8-22
When a switch is in VTP client mode, you cannot change its VLAN configuration.
The client switch receives VTP updates from a VTP server in the VTP domain and
then modifies its configuration accordingly.
Do not configure a VTP domain name if all switches are operating in VTP
client mode. If you do so, it is impossible to make changes to the VLAN
configuration of that domain. Therefore, make sure you configure at least one
switch as the VTP server.
Beginning in privileged EXEC mode, follow these steps to configure the switch
for VTP client mode:
Purpose
Enter VLAN database mode.
Configure the switch for VTP client mode. The default
setting is VTP server.
Configure a VTP administrative-domain name. The name
can be from 1 to 32 characters.
All switches operating in VTP server or client mode under
the same administrative responsibility must be configured
with the same domain name.
(Optional) Set a password for the VTP domain. The
password can be from 8 to 64 characters.
If you configure a VTP password, the VTP domain does
not function properly if you do not assign the same
password to each switch in the domain.
Update the VLAN database, propagate it throughout the
administrative domain, and return to privileged EXEC
mode.
Verify the VTP configuration. In the display, check the
VTP Operating Mode field.
Chapter 8 Configuring VLANs
78-6511-05