Cisco WS-C2950-24 Configuration Manual page 311

Chapter 9 Troubleshooting
Step 16 Enter the password of the failed command switch, and press Return.
Note The password can be from 1 to 25 alphanumeric characters, can start
with a number, is case sensitive, allows spaces, but ignores leading
spaces.
Enter enable secret: secret_password
Enter Y to enter a Telnet password:
Step 17
Would you like to configure a Telnet password? [yes] y
Note The password can be from 1 to 25 alphanumeric characters, is case
sensitive, allows spaces, but ignores leading spaces.
Enter the Telnet password, and press Return:
Step 18
Enter Telnet password: telnet_password
Enter Y to configure the switch as the cluster command switch. Enter N to
Step 19
configure it as a member switch or as a standalone switch.
Note If you enter N, the switch appears as a candidate switch in Cluster
Builder. In this case, the message in
Would you like to enable as a cluster command switch? y
Step 20 Assign a name to the cluster, and press Return.
Enter cluster name: cls_name
The cluster name can be 1 to 31 alphanumeric characters, dashes, or
Note
underscores.
Step 21 The initial configuration is displayed:
The following configuration command script was created:
ip subnet-zero
interface VLAN1
ip address 172.20.153.36 255.255.255.0
78-6511-05
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Step 20 is not displayed.
Recovery Procedures
9-17