Assigning A Public Profile To All Lre Ports - Cisco WS-C2950-24 Configuration Manual

Chapter 7 Configuring the Switch Ports

Assigning a Public Profile to All LRE Ports

Command
Step 1 configure terminal
Step 2
lre profile global profile_name
Step 3
end
Step 4
show controllers lre profile
mapping
78-6511-05
Public profiles are set on a switch-wide (global) basis. The public profile you
select should be compatible with the PSTN to which the LRE switch is connected.
Public profiles have priority over private profiles. If you assign a public profile to
the switch, the switch ignores the private profile settings and uses the public
profile settings on all LRE ports. To disable the public profile on the switch, use
the no lre profile global global configuration command.
Changes to the public profile settings are immediately put in effect, and the public
mode automatically becomes the active mode.
Beginning in privileged EXEC mode, follow these steps to assign a public profile
to the LRE ports:
Purpose
Enter global configuration mode.
Enter the public profile name: PUBLIC-ANSI or
PUBLIC-ETSI.
Return to privileged EXEC mode.
Verify the change.
Use the show controllers lre commands to display the LRE link statistics and
profile information on the LRE ports. For information about these commands,
refer to the Catalyst 2900 Series XL and Catalyst 3500 Series XL Command
Reference.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Configuring the LRE Ports
7-27