Setting Speed And Duplex Parameters; Configuring Flow Control On Gigabit Ethernet Ports - Cisco WS-C2950-24 Configuration Manual

Chapter 7 Configuring the Switch Ports

Setting Speed and Duplex Parameters

Command
Step 1
configure terminal
Step 2
interface interface
Step 3
speed {10 | 100 | auto}
Step 4 duplex {full | half | auto}
Step 5
end
Step 6
show running-config
Step 7
copy running-config
startup-config

Configuring Flow Control on Gigabit Ethernet Ports

Command
Step 1
configure terminal
Step 2 interface interface
Step 3
flowcontrol [asymmetric |
symmetric]
Step 4
end
Step 5
show running-config
Step 6
copy running-config
startup-config
78-6511-05
Beginning in privileged EXEC mode, follow these steps to set the speed and
duplex parameters on a port:
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the port to be
configured.
Enter the speed parameter for the port.
You cannot enter the speed on Gigabit Ethernet or ATM
ports.
Enter the duplex parameter for the port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entry in the configuration file. This
retains the configuration when the switch restarts.
Beginning in privileged EXEC mode, follow these steps to configure flow control
on a Gigabit Ethernet port.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the port to be
configured.
Configure flow control for the port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entry in the configuration file. This
retains the configuration when the switch restarts.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Changing the Port Speed and Duplex Mode
7-3