Configuring The Dsg Client Settings For Advanced-Mode Dsg 1.2 - Cisco cBR Series Configuration Manual

Configuring the DSG Client Settings for Advanced-Mode DSG 1.2

Configuring the DSG Client Settings for Advanced-Mode DSG 1.2
After the global configurations and DSG client configurations are set for DSG 1.2 on the Cisco CMTS, use
the following procedure to continue DSG 1.2 client configurations.
Restriction
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
18
The in-dcd ignore option is not supported by DSG-IF-MIBS specification.
Command or Action
enable
Example:
Router> enable
configure terminal
Example:
Router# configure terminal
cable dsg client-list client-list-id id-index id
{application-id app-id | ca-system-id sys-id |
mac-addr mac-addr | broadcast [broadcast-id
]}
Example:
Router(config)# cable dsg client-list 1
id-index 1 mac-addr abcd.abcd.abcd
cable dsg client-list client-list-id id-index id
[vendor-param vendor-group-id ]
Example:
Router(config-if)# cable dsg client-list
1 id-index 1 vendor-param 1
cable dsg tunnel tunnel id mac_addr mac addr
tg tunnel-group clients client-list-id [enable |
disable]
Example:
Router(config)# cable dsg tunnel mac-addr
abcd.abcd.abcd tg 1 clients 1 enable
cable dsg cfr cfr index [dest-ip {ipaddr
|hostname}] [tunnel tunnel-index ][dest-port
Advanced-Mode DOCSIS Set-Top Gateway 1.2 for the Cisco CMTS Routers
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Sets the DSG client parameters. This command
is changed from earlier Cisco IOS Releases, and
for DSG 1.2, this command specifies the optional
broadcast ID to client ID broadcast type and
vendor specific parameter index.
Sets vendor-specific parameters for the DSG
client.
This command is changed to associate a tunnel
group and client-list ID to a DSG tunnel. Also,
an optional QoS service class name can be
associated to the tunnel.
To associate a cable service class with
Note
an A-DSG tunnel on a Cisco CMTS
router, use the cable dsg tunnel srv-class
command in global configuration mode.
Specifies the DSG classifier index, with optional
support for the DCD parameter, indicating