Chapter 6 Configuring The System - Cisco WS-C2950-24 Configuration Manual

Chapter 6 Configuring the System
Command
Step 1 configure terminal
Step 2
interface vlan 1
Step 3
ip address ip_address
subnet_mask
Step 4
exit
Step 5
ip default-gateway ip_address
Step 6
end
Step 7
show running-config
Note
Command
Step 1 clear ip address vlan 1
ip_address subnet_mask
Step 2
end
Step 3
show running-config
78-6511-05
Beginning in privileged EXEC mode, follow these steps to enter the IP
information:
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the VLAN to
which the IP information is assigned. VLAN 1 is the
default management VLAN, but you can configure any
VLAN from IDs 1 to 1001.
Enter the IP address and subnet mask.
Return to global configuration mode.
Enter the IP address of the default router.
Return to privileged EXEC mode.
Verify that the information was entered correctly by
displaying the running configuration. If the information is
incorrect, repeat the procedure.
Use the following procedure to remove the IP information from a switch.
Using the no ip address command in configuration mode disables the IP
protocol stack as well as removes the IP information. Cluster members without
IP addresses rely on the IP protocol stack being enabled.
Beginning in privileged EXEC mode, follow these steps to remove an IP address:
Purpose
Remove the IP address and subnet mask.
Return to privileged EXEC mode.
Verify that the information was removed by displaying the
running configuration.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Changing IP Information
6-3