Module Message; Port Security Messages - Cisco WS-C2950-24 Configuration Manual

Appendix A System Error Messages

Module Message

Port Security Messages

78-6511-05
with the CPE to achieve the link rate of the profile configured for the port.
When the reduced rate is achieved, link is dropped briefly, and the LRE and
CPE ports attempt to establish the profile link rate. If, after a time (typically
30 seconds), no LRE link is established, this message appears, and the port
LED is amber. The port continues to attempt to establish link, starting from the
reduced rate. This message could also mean that the switch or CPE is faulty.
Action Change the profile on the port to one that has a lower rate or has a
longer reach. There might be too many impairments on the connection
between the switch and the CPE for the ports to sustain the profile rate. If you
suspect the switch or CPE is faulty, contact Cisco Systems.
This section contains the Module error message.
MODULES-3-MAC_TBL_SIZE
This messages means that dynamic module insertion supports less
Explanation
MAC addresses.
Reboot system to use the module.
Action
This section contains the Port Security error message.
PORT_SECURITY-2-SECURITYREJECT
This message means that a packet with an unexpected source
Explanation
address is received on a secure port.
Remove the station with the unexpected MAC address from the secure
Action
port, or add the MAC address to the secure address table of the secure port.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Error Message and Recovery Procedures
A-9