Enabling Vtp Version 2 - Cisco WS-C2950-24 Configuration Manual

Using VTP

Enabling VTP Version 2

Caution
Note
Command
Step 1
vlan database
Step 2
vtp v2-mode
Step 3
exit
Step 4
show vtp status
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
8-24
VTP version 2 is disabled by default on VTP version 2-capable switches. When
you enable VTP version 2 on a switch, every VTP version 2-capable switch in the
VTP domain enables version 2.
VTP version 1 and VTP version 2 are not interoperable on switches in the
same VTP domain. Every switch in the VTP domain must use the same VTP
version. Do not enable VTP version 2 unless every switch in the VTP domain
supports version 2.
In a Token Ring environment, you must enable VTP version 2 for Token Ring
VLAN switching to function properly.
For more information on VTP version configuration guidelines, see the
Version" section on page
Beginning in privileged EXEC mode, follow these steps to enable VTP version 2:
Purpose
Enter VLAN configuration mode.
Enable VTP version 2 on the switch.
VTP version 2 is disabled by default on VTP
version 2-capable switches.
Update the VLAN database, propagate it throughout the
administrative domain, and return to privileged EXEC
mode.
Verify that VTP version 2 is enabled.
In the display, check the VTP V2 Mode field.
8-19.
Chapter 8 Configuring VLANs
"VTP
78-6511-05