Cisco WS-C2950-24 Configuration Manual page 58

Cluster Manager and VSM
Table 2-5 Port Modes
Mode LED
STAT
LRE
(Catalyst 2900 LRE XL only)
FDUP or DUPLX
SPEED or SPD
LINE PWR
(Catalyst 3524-PWR XL only)
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
2-10
Description
Ethernet link status of the 10/100, 100BASE-FX, or 1000BASE-X
switch ports, or the Ethernet link status on the remote CPE.
Default mode on all Catalyst 2900 XL and Catalyst 3500 XL switches
except the Catalyst 2900 LRE XL switches.
Long-Reach Ethernet (LRE) link status of the LRE ports on the
Catalyst 2900 LRE XL switches.
Default mode on these switches only.
When the LRE mode is active, the 10/100 switch ports on
Note
the Catalyst 2900 LRE XL continue to show Ethernet link
status.
Duplex setting on the ports.
Default setting is auto on all Catalyst 2900 XL and
•
Catalyst 3500 XL switches and on the 10/100 ports on the
Catalyst 2900 LRE XL switches.
Default setting is half-duplex on the LRE ports on the
•
Catalyst 2900 LRE XL switches.
On the Catalyst 2900 LRE XL switches, this LED shows
Note
the duplex mode used on the Ethernet link between the
remote customer premises equipment (CPE) and Ethernet
device.
Speed setting on the ports. Default setting is auto.
Note On the Catalyst 2900 LRE XL switches, this LED shows
the link speed between the remote CPE and Ethernet
device.
Inline power setting on the Catalyst 3524-PWR XL 10/100 ports.
Default setting is auto.
Chapter 2 Getting Started with CMS
78-6511-05