Disabling Storm Control - Cisco WS-C2950-24 Configuration Manual

Chapter 7 Configuring the Switch Ports
Command
Step 1 configure terminal
Step 2
interface interface
Step 3
port storm-control broadcast
[threshold {rising
rising-number falling
falling-number}]
Step 4
port storm-control trap
Step 5
end
Step 6
show port storm-control
[interface]

Disabling Storm Control

Command
Step 1 configure terminal
Step 2
interface interface
Step 3 no port storm-control
broadcast
Step 4
end
Step 5
show port storm-control
[interface]
78-6511-05
With the exception of the broadcast keyword, the following procedure could also
be used to enable storm control for unicast or multicast packets.
Beginning in privileged EXEC mode, follow these steps to enable
broadcast-storm control.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the port to
configure.
Enter the rising and falling thresholds for broadcast
packets.
Make sure the rising threshold is greater than the falling
threshold.
Generate an SNMP trap when the traffic on the port crosses
the rising or falling threshold.
Return to privileged EXEC mode.
Verify your entries.
Beginning in privileged EXEC mode, follow these steps to disable
broadcast-storm control.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the port to
configure.
Disable port storm control.
Return to privileged EXEC mode.
Verify your entries.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Configuring Flooding Controls
7-5