Default Vtp Configuration; Configuring Vtp - Cisco WS-C2950-24 Configuration Manual

Using VTP

Default VTP Configuration

Configuring VTP

Note
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
8-20
Table 8-5 shows the default VTP configuration.
Table 8-5 VTP Default Configuration
Feature
VTP domain name
VTP mode
VTP version 2 enable
state
VTP password
VTP pruning
You can configure VTP through the CLI by entering commands in the VLAN
database command mode. When you enter the exit command in VLAN database
mode, it applies all the commands that you entered. VTP messages are sent to
other switches in the VTP domain, and you enter privileged EXEC mode.
If you are configuring VTP on a cluster member switch to a VLAN, first log in to
the member switch by using the privileged EXEC rcommand command. For more
information on how to use this command, refer to the Catalyst 2900 Series XL
and Catalyst 3500 Series XL Command Reference.
The Cisco IOS end and Ctrl-Z commands are not supported in VLAN database
mode.
After you configure VTP, you must configure a trunk port so that the switch can
send and receive VTP advertisements. For more information, see the
VLAN Trunks Work" section on page
Default Value
Null.
Server.
Version 2 is disabled.
None.
Disabled.
8-36.
Chapter 8 Configuring VLANs
"How
78-6511-05