Table of Contents
Advertisement
Bridge Interface
Ethernet
Ethernet1
Ethernet2
Ethernet3
Step 2: Create WAN Interface
Go to Configuration
WAN
wanlink is the factory default WAN interface which is used for data/internet access. If your ISP uses this
access protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE, you
can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to change
the VPI/VCI to 0/40. In South Africa, we use 8/35 for data by default.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN's are supported;
therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 are assigned for video using 1483 Bridged mode. Select RFC 1483
Bridged and click Next to continue the setup.
Chapter 4: Configuration
VLAN Port (Always starts with)
P1 / P2 / P3 / P4
P2 / P3 / P4
P3 / P4
P4
ISP
Billion 800VGT Router
137
Advertisement
Table of Contents
