R3000X Remote Control (Nfu); Js10 Joystick (Nfu) - Simrad AP25 Manual

Simrad AP25 Autopilot
2.6

R3000X Remote Control (NFU)

SIMRAD
STBY-AUTO
Simrad R3000X
Notes !
1. When NAV mode is selected in User Setup
2. When WIND mode is selected in User Setup
3. NAV and WIND
2.7

JS10 Joystick (NFU)

The principle is similar to that of R3000X Remote Control (see
above). The rudder will move as long as the lever is offset to
Port or Starboard. JS10 has no mode change feature.
When a NFU steering lever or a remote control is operated, the
Note !
control units and FU25 become "Inactive".
20
Push button for
Port and Stbd
commands
STBY/automatic.
Automatic modes
are active when
the lamp is lit.
N
Control unit because you have to accept the prompt displays.
In STANDBY mode, the rudder will
move as long as the Port or Stbd
button is pressed.
In AUTO mode and Wind modes the
set course or set wind angle will
change 1° each time the button is
pressed.
If you keep the button pressed, it will
automatically change the setting in
increments of 3° per second.
Mode changes are as per table
below.
Initial mode
STBY
AUTO
NAV
STBY
AUTO
WIND
WINDN
modes can only be entered from the
Note!
st nd
1 press 2 press
AUTO STBY
STBY AUTO
STBY AUTO
2)
STBY
WIND
STBY WIND
STBY WIND
STBY WIND
20221495F
1)3)
2)
2)
3)