Description Of Installation Settings - Simrad AP25 Manual

Simrad AP25 Autopilot
4.2

Description of Installation Settings

The installation settings must be performed as part of the
Note !
installation of the AP25 system. Failure to do so correctly may
prohibit the AP25 from functioning properly!
The Installation menu can only be accessed in STBY mode.
The Installation Settings are grouped into the following
functional categories:
• Language:
• Dockside:
• Interface:
• Display units: Setting the units to be displayed for wind
• Sea trial:
• Parameters:
• Service:
Each group is designed to focus on specific functions, and enable
quick access when changes need to be made.
96
The display will read 'SETUP
REQUIRED'.
Continue with the installation setup
according to the next chapters.
If you already have completed the
installation settings, the autopilot
will enter STBY mode.
Selection of language used for display
information
Items to be set prior to sea trials
These will vary depending on the type of
feedback the autopilot will use (page 67, 100,
109)
Setting the format of the clock/data output for
radars connected to the Autopilot Computer.
speed, water temperature and depth.
Presents settings and automatic calibrations to
be performed during sea trial.
Permits viewing and changing of basic
steering parameters (See also Response
control, page 56).
System data, NMEA data, NMEA test,
SimNet setup, Master reset of memories.
20221495F