Autopilot Computer Installation - Simrad AP25 Manual

Due to space limitations, it may be necessary to cut the length of
Note !
the transmitter rod to move the RF300 closer to the rudder post.
Tighten the mounting screws for both the RF300 feedback unit
and the transmitter rod ball joint.
Observe the RF300 while someone turns the helm wheel through
the complete travel from full port to full stbd. rudder to verify
that the mechanical linkage to the RF300 is not obstructed.
3.7

Autopilot computer installation

The autopilot computer is
designed to operate in a
location that provides
ambient temperatures
below +55°C (+130°F).
The autopilot computer
Note !
units (AC10, AC20 and
AC40) are not
weatherproof and should
be mounted vertically as
shown in a dry place
between the control unit
and the drive unit.
20221495F
Rudder
Feedb.
*
Figure 3-3 RF300 connection
Figure 3-4 Autopilot computer mounting
AUTOPILOT COMPUTER
MAIN PCB
* NON POLARIZED
(COLOR INDEPENDENT)
Installation
69