Transition Speed; Init Nav - Simrad AP25 Manual

Transition Speed

The transition speed is the speed where the AP25 will
automatically change the steering parameter set from HI to LO
parameters, or vice versa (page 22).
The default setting of transition speed is 5 kts.
It is recommended that you set the transition speed to a speed
that represents the speed where the hull begins to plane, or the
speed where you change from slow to cruising speed.
The speed used for the automatic transition is obtained with the
following priority:
1. Speed through water from the speed log source.
2. Speed Over Ground (SOG) from the GPS/Chartplotter.
If no speed data is available, manual speed selection is required.
See also chapters 2.9 and 2.10.
Proceed to next menu item by pressing STBD button.

Init NAV

Sets a firm or soft approach to the track line when entering the
NAV mode at the first leg. The approach angle is dependant
(adaptive) on the distance (XTE) from the track line and the boat
speed.
20221495F
Configuration and setup
Rotate the course dial
clockwise until the transition
speed is set to the desired
value in knots.
Range: OFF – 30 knots
Default: 5 knots
Select firm or soft approach to
the track line by rotating the
course knob.
Range: Soft - Firm
Default: Soft
123