This section offers a tutorial for editing Combinations. If you wish to save an edited Combination,
you must perform a Combination Write operation.)
• If you do not save the edited Combination, the existing Combination will not change. (Refer
to page 106 for information on the Combination Write operation.)
Layering Multiple Programs
You can create a new sound by combining multiple Programs in a Combination. In the following
example, we will edit Combination 58: Moon Stone.
Note: If Combination 58 is not Moon Stone, Preset b Combination may have been loaded. For
this tutorial, ﬁrst load Preset a Combinations to edit. (See page 20, 156.)
1 Select Combination 58: Moon Stone in Combination Play mode.
2 Press the [EDIT] button to enter Combination Edit mode.
Before editing a Combination in Combination Edit mode, you must select a Combination in
Combination Play mode.
3 Press the [PAGE+] or [PAGE–] button to display the appropriate page on the LCD screen.
• You do not have to switch pages; you can change Programs in 0A PROGRAM 1–4 (the page
for Program Timbres 1–4).
4 Press the [ ] and [®] cursor buttons to select a Timbre.
5 Use the [ ] and [ ] buttons to select a Program.
Select the Combination in Combination Play mode.
Press the [PAGE+] or [PAGE–] button to select the page.
Press the [EDIT] button to enter Combination Edit mode.
Change the Programs assigned to Timbres 1–3 and listen to how the sound changes. Combination
58: Moon Stone consists of different Programs assigned to three Timbres as illustrated below.
(Timbres 4–8 are not used.)
You can select Programs to assign to Timbres 1–8 in the 0A and 0B PROGRAM pages. If you
select OFF, that Timbre will not be used.
00A PROGRAM 1-4ø
A78 A37 A05 OFF @ @
Use the [ ] and [ ] buttons to select a Program.
Press the [ˆ] and [¤] cursor buttons to select a Timbre.
A05 : GlockBells
A37 : FreshWaves
A78 : Swell Pad