Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 85

Basic Guide
• When you are using RPN messages, be sure to send the RPN MSB (Controller #101), RPN
LSB (Controller #100), Data Entry MSB (Controller #06), then Data Entry LSB (Controller
#38) in this order. If you do not follow this sequence, the parameters will not be set correctly.
• After setting the parameter values using RPN messages, you can adjust the values using the
Data Increment (Controller #96 set to 0) and Data Decrement (Controller #97 set to 0)
messages.
• Parameter selection by means of RPN messages is memorized until the next RPN messages are
sent or you turn off the power to the X5DR. Therefore, after you have set a parameter value
using RPN and Data Entry messages, if you wish to adjust the value of the same parameter,
you need to send only the Data Entry messages.
72