Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 164

2A – 2D Global MIDI Channel, Note Receive Filter, External Out
Select & MIDI Filter
These pages allow you to set the parameters related to MIDI transmission and reception.
02A MIDI GLOBALø
CH= 1 NoteR:ALL
2A
LCD Parameter
Global MIDI Channel
(CH)
2A
Note Receive Filter
(Note R)
2B External Out Select
Program Change
Filter (PRG)
2C
After Touch Filter
(AFT)
MIDI Controller Filter
(CTRL)
2D
System Exclusive
Filter (EX)
2A Global MIDI Channel: The Global MIDI Channel is used as follows: to receive MIDI data in
Program mode, to select Combinations in Combination mode (when MIDI Filter PRG is set to
ENA or NUM), to control effects, and to send System exclusive messages.
All MIDI data on the X5DR is transmitted on the Global MIDI Channel.
MIDI data for individual Timbres in a Combination and tracks in a song is received on the MIDI
Channels specified in Combination Edit mode (Timbres) and Multi mode (tracks), respectively.
In Combination mode, when a Program Change message is received on the Global MIDI Channel,
a Combination is selected. So, to play a Combination from an external MIDI device, set the Global
MIDI Channel and the Timbre MIDI Channels differently.
MIDI data on the Global MIDI channel is used to control the effects (ON/OFF and Dynamic
Modulation).
Note Receive Filter: The filter is applied to the received note numbers. Normally, this should be
set to ALL. However, if you want to increase the number of available notes by using another
X5DR, X5 or tone generator simultaneously, feed data to both tone generators, and set one to
ODD and the other to EVEN.
02B EXT OUT SELø 02C MIDI FILTERø
MIDI PRG:ENA AFT:ENA
2B
Range
1–16
EVEN
ODD
ALL
MIDI
PCIF
DIS
ENA
PRG
NUM
DIS
ENA
DIS
ENA
DIS
ENA
MIDI OUT
Play
02D MIDI FILTERø
CTRL:ENA EX:DIS
2C
Description
Sets the Global MIDI Channel.
Responds to even notes only.
Responds to odd notes only.
Responds to all notes.
X5DR data is output via MIDI OUT
X5DR data is output via TO HOST
Program Change operation disabled
Program Change messages select Combinations and
Programs
Program Change messages select only Programs (not
Combinations)
MIDI Bank Select messages are not sent or received; only
Program Change messages are received and sent.
After Touch receive disabled
After Touch receive enabled
MIDI Controller receive disabled
MIDI Controllers receive
System Exclusive operation disabled
System Exclusive data sent and received
MIDI IN MIDI THRU
X5DR, X5, 05R/W etc.
EVEN
Reference Guide
2D
MIDI IN
X5DR, X5, 05R/W etc.
ODD
151
5
Global
Parameters