Up To The Maximum Of 64; Wave Sequence Editing - Korg Wavestate Editor/Librarian Owner's Manual

Using the Editor
4. Select Paste from the contextual menu.
Copy/Paste for Wave Sequence Steps
Wave Sequence Steps support Copy and Paste, as well as Cut, Insert Before, Insert After, and Delete. Shift-click to
select a range of Steps, or select multiple non-continuous items by holding down the Command key on MacOS, or the
Ctrl key in Windows. Once you've selected the desired step(s), right-click (or control-click on MacOS) to bring up the
contextual menu and choose the desired copy/paste operation.
If you have cut or copied multiple steps, and then select a range of steps as the Paste destination, the following will
happen:
• If a single step is selected, the steps will be pasted starting at that step, and then replace as many steps as necessary
following that step.
• If you've selected exactly the same number of steps as are on the clipboard, even if they are discontiguous, Paste
will replace only those selected steps.
• If you've selected fewer steps than are on the clipboard, even if they are discontiguous, Paste will replace the select-
ed steps, and then replace as many steps as necessary following the last selected step.
• If you've selected more steps than are on the clipboard, Paste will replace the selected steps with a loop of the clip-
board, stopping at the last selected step.
If you select a range of steps as the Insert Before or Insert After destination, only the first or last step matters. Insert
Before refers to the first selected step, and Insert After refers to the last selected step.
If the Lane doesn't already contain enough steps to complete the paste operation, more will be added to the end, up to
the maximum of 64.

Wave Sequence editing

Wave Sequence
Inspector
Wave Sequence Inspector
This area shows details for the currently selected Lane or Step.
To edit Lane parameters, click on the Lane's title. To edit Step parameters, click on a Step.
Changing the number of displayed steps
Use the 16/32/64 step buttons to adjust the viewable range of the display, to show 16, 32, or 64 steps, respectively.
Editing Start, End, and Loop steps
The triangles above the Steps show the Loop Start (green) and Loop End (red). The triangles below the Steps show the
Start (green) and End (red). To edit, just click and drag on the triangles.
Editing values on the Step graphics
For the Pitch, Gate, and Step Sequence lanes, as well as the Timing Lane when Tempo is off, drag on Steps in the graphic
to edit the Transpose, Gate time, Step value, or Duration, respectively.
For the Sample and Shape lanes, as well as the Timing Lane when Tempo is on, click and hold to bring up a popup menu
to select the Multisample, Shape, or note value, respectively.
7