Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 173

Reference Guide
Combination/Multi mode: With a setting of "PRG (Program)", the panpot setting in Global
mode is used (like in Program Play mode). With other settings, the value of all the indexes are
summarized.
With a setting of "P", the send function in Program Play mode is applied here. With another
setting, the value of all indexes is summarized.
In general, you should set the panpot to "PRG" and send to "P." You can edit the panpot setting
via MIDI when "PRG" or "OFF" is not selected. (The value changes in Combination Edit mode
and Multi mode.) You can also edit the send setting via MIDI. In this case, with a setting of "P",
the send function in Program Play mode is added here. (The send balance between indexes
remains the same.) With a different setting, the values of all the indexes are summarized.
7A–7D Drum Kit2 Setup
These parameters allow you to set up Drum kit2. Operation is the same as for "6A–6D Drum Kit1
Setup" on page 158.
07A DRUM2
152:Timpani
8A Drum Kit Copy
This function allows you to copy a drum kit to the internal Drum Kit 1 or 2.
08A COPY D.KIT
A1 ‡ A2
LCD Parameter
Source Drum Kit
8A Destination Drum Kit
OK to Copy
To copy a drum kit, select the source and destination, position the cursor on OK?, then press the
[ ] button. The message "Are You Sure OK?" will appear. (A1: Drum Kit1, A2: Drum Kit2) Press
the [ ] button to copy, or the [ ] button to cancel.
Note: The drum kit at the specified destination is overwritten when this function is executed. So
be careful that you don't overwrite (lose) a valuable drum kit.
160
#01ø 07B KEY/TUNE/L ø
D#4 T+019 L+65
7A 7B
OK?
8A
Range
A1, A2, ROM 1–8
A1, A2
OK?
07C DECAY/ASGN ø 07D PAN/SEND
Dcy+00 Asgn:EX1 Pan=CNT C=0 D=0
7C
Select the source drum kit
Select the destination drum kit
Executes the copy
ø
7D
Description