802CN/802-II
Users Manual
Power On/Off
Push and hold O for over one second to turn on/off the
Product. See
Table 3
for the control location.
When you turn on the Product, the default Measurement
screen shows. The screen shows the same measurement
units since you last powered off the Product.
Auto Power Off
After 300 seconds of inactivity, the Product automatically
powers off.
How to Operate
This section is about the operation of the Product. It
includes measurement tips and step-by-step instructions.
Keys
Table 3
shows the keys on the Product.
For general operation:
•
Push and hold
reading hold.
•
Push
to change measurement mode/unit or record
a reading.
6
to start measurement or release
•
Push
to view existing reading or clear all stored
data.
Measurement Modes
The units of measure are adjustable for different standards.
In standby mode (when the main screen shows ----):
Push
to switch between measurement modes
(acceleration/velocity/displacement) and measurement
units (LO m/s², Hi m/s², mm/s, and mm).
Quick Measurement
Push the sensor tip onto the test surface
vertically. Otherwise measurement accuracy is
affected. See
Figure
Note
1.