Connecting A Network Device To A Fiber Port - Dell PowerConnect B-TI24x Hardware Installation Manual

3
Connecting network devices
For more information about this feature and how configure it, refer to the PowerConnect B-Series
TI24X Configuration Guide.

Connecting a network device to a fiber port

For direct attachment from the Dell PowerConnect device to a Gigabit NIC, switch, or router, fiber
cabling with an LC connector is required.
To connect the Dell PowerConnect device to another network device using a fiber port, you must do
the following:
•
•
The following sections provide information about performing these tasks.
Installing a fiber optic module
You must install a fiber optic module (SFP or SFP+ transceiver) in each Gigabit Ethernet and
10-Gigabit Ethernet fiber port you want to use.
You can install a new fiber optic module in a port while the Dell PowerConnect device is powered on
and running.
To install a fiber optic module, you will need an ESD wrist strap.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
Follow the steps to install a fiber optic module.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface
2. Remove the new module from its protective packaging.
3. Gently insert the fiber optic module into the port until the module clicks into place. The module
Cabling a fiber optic module
Follow the steps to cable a fiber optic module.
1. Remove the protective covering from the fiber-optic port connectors and store the covering for
2. Before cabling a fiber optic module, Dell strongly recommends that the cable connectors and
3. Gently insert the cable connector or connectors (a tab on each connector should face upward)
4. Observe the link and active LEDs to determine if the network connections are functioning
28
Install a fiber optic module (SFP transceiver or mini-GBIC for Gigabit Ethernet ports, or SFP+
transceiver for 10-Gigabit Ethernet ports)
Cable the fiber optic module
(such as an equipment rack) to act as ground.
is keyed to prevent incorrect insertion.
future use.
the port connectors are cleaned thoroughly.
into the port connector or connectors until the tabs lock into place.
properly. Refer to Table 5.
Dell PowerConnect B-Series TI24X Hardware Installation Guide
53-1002265-01