Table of Contents
Advertisement
2
Powering on the system
FIGURE 6
5. Proceed to
Powering on the system
Note the following before powering on the system:
•
•
•
•
•
•
NOTE
Align the locating notch on the underside of the AC PDU power cords (C13-C14) before inserting.
18
Installing the device in a rack
"Powering on the
The AC outlet should be installed near the equipment and should be easily accessible.
Get the appropriate cable for the AC outlet.
If your installation requires a different PDU power cords (C13-C14) than that supplied with the
device, make sure you obtain a PDU power cords (C13-C14) displaying the mark of the safety
agency that defines the regulations for PDU power cords(C13-C14) in your country. The mark is
your assurance that the PDU power cords (C13-C14) can be used safely with the device.
Ensure that all power supplies are fully and properly inserted.
Remove the PDU power cords (C13-C14) from the shipping package.
Attach the AC PDU power cords (C13-C14) to the AC connector on the rear panel as shown in
Figure
7.
system".
Dell PowerConnect B-Series TI24X Hardware Installation Guide
53-1002265-01
Advertisement
Table of Contents
