Dell PowerConnect B-TI24x Hardware Installation Manual page 26

2
Installing the device
A rack mount kit with short mounting brackets ships with the device.
In addition to the rack mount kit, you will need the following tools for installation:
•
•
•
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device at
the bottom and progressively place lighter devices above.
DANGER
Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
DANGER
Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.
DANGER
Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air
flow required for safe operation of the equipment is not compromised.
DANGER
Circuit Overloading - Consideration should be given to the connection of the equipment to the
supply circuit and the effect that overloading of the circuits might have on overcurrent protection
and supply wiring. Appropriate consideration of equipment nameplate ratings should be used
when addressing this concern.
16
#2 Phillips-head screwdriver
Four 12-24 screws to mount the PowerConnect device in the two post equipment rack.
Four 10-32 screws to mount the PowerConnect device in the four post equipment rack.
Dell PowerConnect B-Series TI24X Hardware Installation Guide
53-1002265-01