Dell PowerConnect B-TI24x Hardware Installation Manual page 27

DANGER
Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to the
branch circuit (e.g. use of power strips).
Follow the steps to install the rack mount brackets and mount the device in a rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two mounting brackets.
2. Place the Network switch on a hard flat surface with the front panel facing you.
3. Attach a rack-mount bracket to one side of the Network switch with the supplied screws. Then
4. Attach retainer nuts into the non threaded holes in the four post rack. Use 10-32 screws to
DANGER
Make sure you use the screws supplied with the mounting brackets. Using the wrong screws
could damage the PowerConnect B-Series TI24X and would invalidate your warranty.
Figure 5
FIGURE 5
Mount the device in the rack as illustrated in
Dell PowerConnect B-Series TI24X Hardware Installation Guide
53-1002265-01
attach the other bracket to the other side.
attach brackets to the rack.
shows how to attach the short mounting brackets.
Attaching the short mounting brackets
Installing the device
Figure 6.
2
17