Removing Mac Address Entries - Dell PowerConnect B-TI24x Hardware Installation Manual

To change the device poll time, enter a command such as the following at the global CONFIG level
of the CLI.
PowerConnect(config)# chassis poll-time 200
Syntax: chassis poll-time <value>
NOTE
The <value> can be 0 - 65535 seconds.

Removing MAC address entries

You can remove learned MAC address entries from the Dell system MAC address table. You can
remove the following entries:
•
•
•
•
For example, to remove entries for the MAC address 000d.cb80.00d in all VLANs, enter the
following command at the Privileged EXEC level of the CLI.
PowerConnect# clear mac-address 000d.cb80.00d0
Syntax: clear mac-address <mac-address> | ethernet <port-num> | vlan <number>
If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
Use the <mac-address> parameter to remove a specified MAC address from all VLANs. Specify the
MAC address in the following format: HHHH.HHHH.HHHH.
Use the ethernet <port-num> parameter to remove all MAC addresses for a specified Ethernet port.
Use the vlan <number> parameter to remove all MAC addresses for a specified VLAN.
Dell PowerConnect B-Series TI24X Hardware Installation Guide
53-1002265-01
All MAC address entries
All MAC address entries for a specified Ethernet port
All MAC address entries for a specified VLAN
A specified MAC address entry in all VLANs
Removing MAC address entries
4
35