Panasonic KX-TDA600 - Hybrid IP PBX Control Unit Max. 1008 Ports Installation Manual page 197

2.
Pass the wires through the hole in the base cover, and attach the base cover to a wall using 2 screws.
Screw
Note
Two kinds of screws are included with a KX-T30865. Please choose the appropriate kind for your wall
type.
: when a doorphone plate has been fixed to the wall
: when you wish to install the doorphone directly onto the wall
3.
Connect the wires to the screws located in the front cover.
4.
Re-attach the 2 halves and re-insert the screw.
Connection
Use 8-pin and 10-pin terminal blocks (included with the card) for connection.
1.
While pressing down on the hole at the top of the terminal block using a screwdriver, insert the wire into
the side hole as shown below. Repeat this procedure for other doorphones, door openers, external
sensors, and external relays.
Refer to "2.8.2 DPH4 Card (KX-TDA0161)" and "2.8.3 EIO4 Card (KX-TDA0164)" for pin assignments.
Doorphone
Door Opener
External Sensor/
External Relay Device
2.11 Connection of Doorphones, Door Openers, External Sensors, and External Relays
To 8-pin terminal block
To 8-pin terminal block
Installation Manual 197